More large cobbles and boulders are present at Site 3, although the authors sampled mostly sand from the lee of a ∼2 m diameter boulder. Although more detailed sediment grain size analysis was not done, all samples were predominantly sand with small fractions of silt (included in analysis) and gravel (discarded, as described in Methods). Each sample also had consistent down-core sediment size, as

each core was visually analyzed and cataloged before analysis. The authors sampled sediment from within-channel areas where potential sediment depositional areas are, such as pools, at baseflow conditions. We obtained samples between May 27 and July 11, 2011, and there were no flood events on the Rockaway River (as measured by the USGS gage #01380500 just downstream of Site 3) between sampling dates. There was a flooding event (May 20) one week prior to the beginning of sampling but sampling was completed before the find more large flooding event form Hurricane Irene in August/September 2011. The land use for Site 1 was predominantly forested (78%) in 2006 (the most recent National

Land use Cover Database (NLCD) available) with 17% urbanized (Table 1). However, most of this urbanized land use was low-density residential development (13%). Sites 2 and 3 had more urbanized land (25%) and also much more highly-developed land (7%) than Site 1 (Table 1). This highly-developed land is classified as having less than DAPT 20% vegetation

with the rest constructed land cover. At each site we hammered a Φ = 5.5 cm (2 in.) Resveratrol wide PVC pipe into the river bed to collect a sediment core approximately 10–15 cm in length. We then segmented cores into either 1 cm or 2 cm slices, increasing with depth, in the field and individually stored in clean polyethylene sample bags. We removed grains larger than coarse sand (∼2 mm), dried the samples at 40 °C for 24 h or longer to a constant weight, and ground each in a crucible. We then weighed and sealed approximately 50 g of the dried samples in a plastic sample jar for a minimum of three weeks before the sample was counted for 222Rn (t½ = 3.82 d), to reach a secular equilibrium with 226Ra (t½ = 1600 y). We used identical sample jars to minimize distortions from different geometries. After the three weeks, radionuclide (7Be, 137Cs and 210Pb) activities were measured with a Canberra Model BE2020 Broad Energy Germanium Detector equipped with Model 747 Canberra Lead Shield housed in the Montclair State University Geochemistry Laboratory ( Olsen et al., 1986, Cochran et al., 1998, Feng, 1997 and Whiting et al., 2005). The authors ran each sample for ∼24–48 h to ensure sufficient accuracy and precision. We determined the 7Be, 137Cs and 210Pb from the gamma emission at 477.6 keV, 662 keV and 46.5 keV, respectively, and measured the supported 210Pb (226Ra) activity via 214Pb gamma emissions at 352 keV.